Welcome to Shandong EAAK Machinery Co., Ltd

+86-531-82020399 info@eaaklaser.com
Laser cutting machine,laser cutter,laser engraving machine,fiber laser metal cutting, > News > Industry Dynamics >

What should we prepare for new fiber laser cutting machine?

Post time:2019-07-11    By:EAAK    Clicks:
1.Choose equipment that is dry, ventilated, with good air quality and sufficient space. After the new machine is placed in the proper position, fix the equipment;
2. Although the newly purchased equipment is in the manufacturer's place, the relevant parameters are debugged and tested, but the new purchase will inevitably be bumped due to road transportation. Therefore, after the new machine is grounded, it needs to be re-commissioned on site;
3.When cutting with new equipment, try to avoid cutting the cutting speed to the limit;
4.Almost all equipment supports 24-hour continuous operation, but during the operation of the new machine, try to avoid 24-hour overload cutting in order to catch up with the capacity. This is not only suitable for new machine use skills, but also for subsequent cutting work. The same applies to
5.After the equipment arrives at the factory, there are professional after-sales engineers to carry out training on equipment operation. Be sure to pay attention to it and pay attention to some precautions for operation to avoid machine failure caused by improper operation in a short time.
6.In the event of equipment failure, communicate with the manufacturer's after-sales in a timely manner.
Finally, the newly purchased laser cutting machine must pay attention to daily maintenance and maintenance to achieve the maximum use value of the equipment and extend the service life of the equipment.

Recommended Reading

Protect laser water cooler in winter

Liquids all have freezing point. When the temperature of the liquid is lower than this freezing point temperature, it wil...

How to protect laser power source in summer?

How to protect laser power source in summer?The most important part is keep cooling.Choose right water/oil cooler for fib...

Why the price of laser cutting machine different but similar configuration?

Someone want to buy laser cutting machines from China and found that there is a strange phenomenon--two sets of laser mac...

The cause and solution of burrs on the edge of laser cutting metal.

The cause and solution of burrs on the edge of laser cutting metal.Why does the burrs appear when laser machine cutting m...

Laser cutting machine cuts stainless steel

Stainless steel laser cutting machine is higher in cost than wire cutting, and the precision is not as good as wire cutti...

Focus point affects the cutting accuracy of fiber laser cutting machine

The influencing factor of the cutting quality of fiber laser cutting machine——focus position adjustment, because the ...